Gas piping for Utah homes and buildings.
DML Mechanical installs natural gas piping for furnaces, boilers, water heaters, rooftop units, fireplaces and ranges on new construction and remodel projects in Utah. Our team is trained through the Rocky Mountain Gas Association and works to the Utah fuel gas code.
Every phase, one accountable crew.
Work from our jobsites.
Ballpark your system before you call.
Sized, installed and tested to pass.
Sized for the connected load
We size gas piping for the total connected load and the length of each run, so every appliance gets the pressure it needs, including at high altitude.
Installed and tested to pass
Our crews install black iron and approved flexible gas piping with proper supports, sediment traps, shutoff valves and appliance connections, then pressure test the system for the inspector.
Venting and combustion air
Gas appliances are only as safe as their venting. We route vents per the manufacturer's instructions with correct slope and terminations, and provide combustion air where the appliance requires it.
Residential and commercial
From furnace, water heater and fireplace lines in new homes to rooftop unit and make-up air connections on commercial buildings, we coordinate meter sizing and gas service with the utility and the general contractor.
Part of the full HVAC scope
Because gas piping, venting and equipment are installed by the same crew, there are fewer trades to coordinate and fewer gaps between scopes.
Areas we serve
Salt Lake, Utah, Davis, Weber, Summit and Wasatch Counties, from Ogden to Provo and Park City.
Send your plans or call (385) 307-8871. We respond within one business day.